Home
  • Home
  • About Journal
  • Editorial Board
  • Aim & Objectives
  • Authors Instruction
  • Current Issue
  • Special Issue
  • Archive
  • Submit Article
  • Contact Us

EDITOR-IN-CHIEF

 Dr. Khuda Bakhsh, Ph.D.,

Professor,Department of Education GC University Faisalabad Pakistan.
Email: khudabakhsh@gcuf.edu.pk
editorinchiefijmasri@gmail.com


Publisher


KRISHMA PUBLICATION (Reg 17/2020)
2 /57 A,
Middle street, Pali, Pali, Viluppuram,
Ulundurpettai, Tamil Nadu,
606104
Email: krishmapublication@gmail.com



Categories

  • Journal Home
  • About IJMASRI
  • Current Issue
  • Instruction to Author
  • Indexing & Abstracting
  • Impact Factor
  • Submission Guidelines
  • Joint as Editorial Board
  • Publication Ethics

WELCOME TO IJMASRI

SUBMISSION GUIDELINES:

International journal of Multidisciplinary advanced scientific research and innovation (IJMASRI) welcome the articles, original research papers, manuscript from the research scholars, academicians, and industrials in the area of multidisciplinary research.

All manuscript must be submitted to through the e-mail to the articleadvancedscientific@gmail.com for fast processing.

Authors are advised to follow the author guidelines in preparing the manuscript before submission.

Publication terms:

Submitting your manuscript to International journal of Multidisciplinary advanced scientific research and innovation (IJMASRI) means that your work has not been published before in any other journal, book or in a book chapter, be it printed or online (except in the form of an abstract or an academic thesis) that it is also not in any way under consideration for publication elsewhere.

  • After receiving author manuscript, the editor will then send a confirmation e ???????? Mail to corresponding author only. Within 24 hours in working day.
  • The mail should contain the author full address, telephone numbers (or) mobile numbers designation. It any co- author it should be followed by first author.

International journal of Multidisciplinary advanced scientific research and innovation (IJMASRI) publish research papers, case studies, short communication containing original research work of good standard and review papers of contemporary relevance from all over the world. Following types of contribution are considered for publication:

  • Research papers
  • Case studies
  • Short communications
  • Review papers

Authorization and Declaration:

Authors must accept full responsibility for the content of their articles. The members of editorial board and the publisher of the journal are not responsible for the statements and opinions expressed by the authors in their articles/ write-up published in the journal.

Articles type:


Original research Articles:

The length of paper should be 10-15 pages. The paper should be original in nature, research findings and working relates to the research work to be given in detail to verify the work by others.

Short communication:

The short communication is suitable for new model, innovative methods and techniques. It should be sent maximum of 2 to 4 pages in length.

Reviews:

Review can be made by authors in the current topics and intensive areas. It must be 4 to 6 pages. Reviews are also peer-reviews.

Case reports:

Novel / interesting / extremely rare cases or rare presentation can be reported. Cases with clinical significance or implications will be given priority-up to 3-4 pages.

Review process:

Review process done by editor in chief and member of executive editors. Decision will be made by editorial board within a week.

Original research articles:

Research articles must be typed and all pages are to be numbered. Title page must include full name of the author, phone number, mobile number, e- mail ID and present address.

The abstract state that the scope of research and point out materials and methods findings and conclusion. The abstract must be in complete sentence, verbs should be clear and abstract should be written in the past tense. Three to ten key words will be provide index reference should be listed.

Format of manuscript:

Manuscript should be divided into title page, abstract, introduction, materials and methods, result, Discussion or result and discussion, conclusion, acknowledgement and references.

Title page:

In separate line, title page should contain the title of the manuscript, the name(s) and affiliation(s) of the author(s) and e-mail address of the corresponding author. The title must be specific can use and informative.

Key words and abstract:

Please include 3-10 keywords for indexing purposes; full length manuscript submission should contain an abstract of up to 250 words in a structural form, consisting of objectives, methods, result and conclusion.

Introduction:

Introduction must be in clear and staining that reasons for carry out of research work, background regarding the research work, background regarding the research nature of hypothesis should be clearly stated. The introduction should be understandable to reaches from various science disciplines.

Materials and method:

Materials and methods do not refer to common place statistical test. It must be enough to allow experiments to be reproduced. If any previous published research work can also be cited and notification should be mentioning clearly, subheadings should be used.

Result:

Result of research articles or manuscripts should be present with clarity and precise. Previous publisher????????s finding should be written in present tense. Results should be explained. Discussion interpretation should be included in the result but should be put into the discussion selection.

Discussion:

Discussion part of the research paper includes the sub heading, significance of the results related to research work.

Acknowledgements:

In this area, the authors may wish to thanks same research institutions funding agencies, companies or governmental bodies, grants or people who have contributed or financially supported the research from which the manuscript is derived.

Tables:

Tables and chart in the research paper should be kept minimum and simple. It should be double line space including the heading and foot not. Table should be presented in separate page. It should be numbered. Table must be preparing in ms word.

Figure legends:

Figure in the paper brought in a numerical order on a separate sheet. Graphics should be preparing with resolution GIF, JPEG, TIFF and power point pasting in ms word file. Use Arabic numerical for figures and upper case letter for their.

Conclusion:

Manuscript should have relevant brief conclusion and should reflect the importance and future scope. The main conclusion of the experimental work should be presented. The contribution of the work to the scientific community and its economic implications should be emphasized.

Reference:

In the text, a reference identified by means of an author????????s name should be followed by the date of the reference in parentheses. When there are more than two authors, only the first author????????s name should be mentioned, followed ???????et al ???????. In the event that an author cited has had two or more works published during the same year, the reference, both in the text and in the reference list, should be identified by a lower case letter like ???????a???????? and ???????b???????? after the date to distinguish works. Reference should be listed at the end of the paper in alphabetical order. Authors are fully responsible for the accuracy of the references.

Examples:

Text citation

Single author: the author????????s name (without initials) and the year of publication e.g. Awis (2010) or (Awis, 2010)
Two authors: both author????????s name and the year of publication e.g. John and smith (2010) or (John and smith, 2010)
More than two authors: It a citation has more than two authors the first author should be given followed by et al. In standard text format (not italized). E.g. Jones et al., (2007) or Jones et al., 2007. 
Multiple citations
(Braard, 1945; Ballek and Swift, 1986; figuiraset et al., 2013) Multiple publications by the same authors:
(Anderson 1989a,b,c,d,e)

End list citations

Single Author
Bashan, Y. (1986). Alginate beads as synthetic inoculants carriers for release of bacteria that affect plant growth. Appl. Environ. Microbiol., 51: 1089-1098.
Single Author: More than one publication in the same year
Sparrow, S.D. and Ham, G.E. (1983a). Nodulation,N2fixation, and seed yield of navy beans as influenced by inoculant rate and inoculant carrier. Agron. J. 75: 20-24.
Sparrow, S.D. and Ham, G.E. (1983b). Survival of Rhizobium phaseoli in six carrier materials. Agron. J. 75: 181-184.

Two Authors

Attia, M. and N.M. Awad. (2003). Assessment the impact of growth promoting rhizobacteria strains on symbiotic effectiveness of arbuscular mycorrhizal fungi. Egypt J. Microbiol., 38(1): 75-88.

More than Two Authors

George, E., K. Haussler, D. Vetterlein, E. Gorgus and H. Marschner. (1992). Water and nutrient translocation by hyphae of Glomus mosseae. Can. J. Bot., 70: 2130-2137.

Short communication:

Short communications are limited to a maximum of two figures and one table. The research and technical communications section of this journal (maximum 3,000 words) is open to interesting results worthy of publication without requiring extensive introduction and discussion. This section should be organized as follows: Abstract, Introduction, Materials and methods, Results and discussion (combined).Not more than 10 references should be provided. Tables, figures and references are to be arranged in the same way as for research papers.

Copyright

Submission of a manuscript implies; that the work described has not been published before (except in the form of an abstract or as part of a published lecture, or thesis) that it is not under consideration for publication elsewhere; that if and when the manuscript is accepted for publication, the authors agree to automatic transfer of the copyright to the publisher.

Terms

After acceptance of the manuscript with the journal formatted proof, authors must pay the processing charges as prescribed in the guidelines to authors. Once paid the processing fees it should not be refund from publishers. Because we are charging only the processing fees, it includes reviewers report preparation, editing, proof reading, design, formatting and maintenance.

publication fees:

                        There is no charge for the processing of paper but author(s) each accepted paper is required to pay the publication charge which is very nominal fees. Before the accepted paper is published we will intimate the fees in the acceptance letter.

Payment mode:

After completion of payment, author has to fill the detail of amount, cheque and demand draft number and using bank name in case of payment transfer by cheque / demand draft or only transaction id in case

For Indian authors:

If you do not have any bank account also you can directly deposit cash or money order (MO) in our bank account. It is compulsory send payment details (i.e. soft copy of cash receipt, DD details, cheque Details) at paymentsadvancedscientific@gmail.com

For foreign authors:

The foreign authors can also transfer the publication charges by using western union money transfer, Money gram, Xpress money. Compulsory send payments details at paymentsadvancedscientific@gmail.com

Announcement


Call for papers Vol 5, February 2025

Submit your articles in articleadvancedscientific@gmail.com

www.advancedscientificjournal.com

Publish within 48 hours
Fast Publication  publish within 48 hours

Subject Area

Agricultural Sciences

  • Agricultural microbiology
  • Agricultural extension
  • Agricultural biotechnology
  • plant technology
  • environmental science
  • plant and biotechnology
  • More→

Life Sciences

  • General Microbiology
  • Botany
  • Zoology
  • bio technology
  • medical microbiology
  • More→

Social Science and Humanities

  • Economics
  • Education
  • English
  • Literature
  • women studies
  • Entrepreneurship
  • More→

Health Science

  • Medical
  • Dental sciences
  • Physiotherapy
  • Nursing care
  • Biotechnology
  • Pharmacy
  • More→

Physical Sciences and Engineering

  • Electrical Engineering
  • Electronics & Communication
    Engineering
  • Graphics and Multimedia
  • Software Engineering
  • Biological Engineering
  • More→

Copyright@2019 International Journal of Multidisciplinary Advanced Scientific Research and Innovation . All rights reserved. Developed by - Microbotware Technology